ICC1-232 RS-232 Display Controller

Installation

AC Power Test

1. Insert DC power supply plug into 12 VDC jack.
2. Plug power adaptor into AC wall outlet.
3. The Net LED should turn on and stay lit.

RF Coax and iCC-Net Operation

1. Connect the display to CATV and observe quality of RF broadcasting. A low-quality CATV system can also affect performance of the iCC-Net commands. If needed, fix CATV problems before installing the system.
2. Connect the CATV RF Coax cable into the RF In input on the iCC1-232.
3. If the iCC-Net signal is operating, the Net LED will blink once per second.
4. Connect the RF loop cable from the RF Out jack to the TV’s RF connector (remember, you lose less than 1.5 dbmV by going through the ICC1-232’S internal RF tap).

RS-232 Control Codes

Presently, one control type is installed at the factory, updateable to other types through the RF.

MFG	Type	Kbd	Models	Notes	Ver
LG	LCD	9.6	9600 baud		2.2
Sharp HD	LCD	9.6			2.9
Westinghouse	LCD	9.6	Pro AV Models		1.5
Sampo	LCD				2.0
Revolution HD	LCD				2.3
Enseo Sony ICS-SP30	LCD	115.2	Enseo tuner for Sony KVM hospitality sets		2.5
NEC	LCD		Commercial sets with AVT tuner		2.6

© 2010 Contemporary Research Corporation.
Contemporary Research® is a registered trademark of Contemporary Research Corporation. All rights reserved.