ICC-PRZ Smart Display Controller

Overview | Specifications | Installation

Documents | Data Sheet | Manual | ICC1-PRZ Drawing | ICC2-PRZ Drawing

Specifications

Physical

Size: 5.47" [139mm] wide x 6.35" [161mm] height x 1.13" [29mm] deep
Weight: 12 oz [341g]
Enclosure: All aluminum with durable black powder coat paint
Mounting: Mounts on rear of display

Front Panel Status

Net LED: Green LED for iC-Net bus, flashes once per second if receiving communication
TV/COM LED: Yellow LED, flashes when receiving IR data, stays off when Smart data not active
Error LED: Red LED indicates a problem within the unit

Connections

RF Out: Internal RCA female, 75 ohm impedance, RF to TV
Ant/Cable: 'F', female, 75 ohm impedance, RF from CATV system
iCC-Net: Carried over the same RF coax connection as TV channels
  Receive: Mid-band VHF, 74.7MHz, sent from IC Head-End Network Controller
  -25 to +35 dBmV signal level
  Transmit: Sub-band, 5.6MHz sent to Head-End Network Controller
  +/- 80 KHz max carrier deviation, +49dBmV nominal (ICC2 models only)
To TV: RJ-12 female 6-pin Telco jack, accepts included Smart TV data cable
Power In: 2.1mm coaxial jack (inside center conductor positive), 100 mA maximum 9 to 16.5 VDC, 12 VDC typical (may be unregulated)
RCA Smart displays will power ICC-R controllers, external supply required for Philips and Zenith models.

Includes

Smart TV data link cable
Mounting hardware
RF Loop Cable

Space-saving 12 VDC 500 mA digital switching power supply (North American shipments only)

Options

IC-RC Wireless IR Remote for user control and system setup
Internal buzzer used for system-activated alerts