232-Amp Stereo Mixer/Amplifier

Installation

DIP Switch and Gain Setting

All the parameters can be programmed via RS-232, but many can be set using the DIP switch on the bottom of the case and the Gain potentiometer on the front panel

Select Input and Gain

1. Stereo input = Switches 1 and 2 OFF
2. Mono 1 = Switch 1 ON to In 1
3. Mono 2 = Switch 1 off , switch 2 ON to In 2
4. Use GAIN pot to set gain for selected input

RS-232 Baud Rate
Set switch OFF for 9600 baud or ON for 1200 baud.

RS-232 Cabling

232-Amp alone:

232-Amp and CR 232-Series Tuner

Rack Mounting

The RK3 Rack Mount Kit makes it a snap to rack-mount and install many CR System Tool products. Simply attach the System Tool into one of three positions on the RK3, placing the included screws into pre-tapped holes in the back of the System Tool. All the connections are on one side, facing the back of the rack. Couldn't be simpler.

Size: 19.0" [483mm] wide x 1.73" [44mm] 1RU height x .437" [11mm] deep
Mounting: Three mounting spaces, each space accepts two 4-40 ¼” screws 4.25” apart to attach System Tool

© 2010 Contemporary Research Corporation.
Contemporary Research® is a registered trademark of Contemporary Research Corporation. All rights reserved.